Page 143

EAP Policy Manual FFY24 Chapter 6 Energy Related Repair Page 3 example. Because a biofuel heating system needs frequent resupplying of fuel, it is not considered redundant. • Dual System Furnace: A general HVAC or heating term used to describe a furnace that uses more than one fuel source to provide heat in a dwelling unit. • Non-Traditional: Furnaces not in general use. • Off-Peak or Dual Fuel Discount Programs: Electric discount programs requiring the household to use another heating fuel type when electric heat is switched off. This is not considered a redundant heating system because it does not provide continuous heat. ERR Assessment The intention of ERR is to restore heat where there was once heat provided by the existing heating system. ERR is allowed for primary furnaces if there is no redundant heating system to provide heat to the same area of the dwelling. In determining the appropriate ERR activity, the Service Provider should assess the structure of the dwelling, how the furnace provides heat to the house and the heat provided by any secondary heating system. This assessment allows the Service Provider to determine the validity of the ERR event using the intentions and definitions. • ERR focuses on the primary furnace and not secondary or back up furnaces. • A household may have a secondary heating system that could be used as a primary furnace if the secondary furnace is both a legitimate option to restore heat and is a cost effective alternative. It may be cost effective to repair or replace the secondary heating system rather than the primary furnace. • A non-traditional heating system may not be replaced or repaired with ERR funds if it is redundant or if a less expensive traditional furnace or system is possible. Examples of non-traditional furnaces/systems include: heat pumps, outdoor biomass furnaces/boilers, radiant floor, and fireplace inserts. • Non-electric heating systems may be repaired or replaced when households utilize off- peak or dual fuel discount programs because heat may not be continuous. • A dwelling must have adequate electrical service to operate the heating system for the furnace to be repaired or replaced. ERR electrical repairs outside of the furnace are limited to the wiring (dedicated circuit) that connects from the furnace to the service panel or from the furnace to the thermostat. ERR may not be used for: • Non-emergency repairs or replacements. • Repairs or a replacement not initiated by the EAP Service Provider. • Unoccupied dwellings. Example: The household purchased a house and cannot move in until the furnace is repaired or replaced. • A dwelling that currently does not have an installed furnace.